Psychology World — home
Blog

Action potential in psychology: the all-or-none spike that carries every signal

What an action potential is in psychology, its phases, threshold and all-or-none rule, with a one-question test and study tips.

Neuroscience8 min read
By Psychology World

An action potential is a brief, all-or-none electrical spike that travels down a neuron axon without losing size once the membrane reaches threshold. At rest the inside of the neuron sits near minus 70 millivolts. Inputs that push it to about minus 55 to minus 50 millivolts open sodium channels, sodium rushes in, then potassium leaves, and the spike moves forward to the synapse.

  • An action potential is a spike, not a graded change. It either fires fully or does not fire.
  • Rest sits near minus 70 millivolts. Threshold sits at about minus 55 to minus 50 millivolts.
  • Below threshold nothing happens. At threshold and above, a full-size spike always follows.
  • Sodium inflow causes depolarization. Potassium outflow causes repolarization and a brief dip below rest.
  • The patch behind the spike cannot fire again yet, so the signal moves forward only.
  • Myelin speeds the signal by letting it jump between bare gaps called Nodes of Ranvier.

What an action potential is

An action potential is a rapid, short change in the voltage across a neuron membrane that carries a message along the axon. In psychology it matters because messages between neurons travel as such spikes. Only neurons and muscle cells make them. That property is called excitability.

The spike does not fade with distance. Each patch of axon membrane rebuilds a new full-size spike in the next patch. The target thus gets the same size signal no matter how far it sits from the cell body.

Much of the early evidence came from the squid giant axon. That axon can reach 1 millimeter in diameter and runs from the head to the tail of the animal. Its size made it possible to record the voltage changes directly.

The threshold test

At rest a neuron holds a stored voltage difference. The inside is negative relative to the outside, near minus 70 millivolts. Selective channels let potassium pass easily while sodium and chloride pass with more difficulty, and large negative proteins cannot leave the cell. A pump keeps this balance by moving three sodium ions out for every two potassium ions it brings in.

Inputs shift this voltage up and down. Some inputs push it toward positive values. Others hold it back. The neuron adds these small graded changes together across space and time. When the sum reaches threshold, the spike starts.

Threshold sits at about minus 55 to minus 50 millivolts. Different summaries give slightly different values in this range, so learn the range rather than one fixed number. The rule is simple. A subthreshold stimulus causes no spike. A threshold stimulus causes a full spike. A stronger stimulus also causes a full spike of the same size.

Use this one-question test on any example. Did the membrane reach threshold, and did a full-size spike regenerate forward. If yes, it was an action potential. If the change stayed below threshold and faded with distance, it was a graded change.

The phases in order

The spike follows the same order every time. Sodium channels open fast. Potassium channels open later and close slowly. That timing gives the trace its shape.

The five states from rest back to rest.
StateWhat happensIons
RestInside near minus 70 millivolts, stable differencePotassium leaves easily, pump keeps balance
DepolarizationVoltage rises fast past threshold to a brief positive peakSodium channels open, sodium rushes in
PeakBrief positive top, then sodium channels closeSodium entry stops
RepolarizationVoltage falls back toward restPotassium channels open, potassium leaves
HyperpolarizationVoltage dips below rest, then returns to restPotassium channels stay open too long

At rest the membrane holds about minus 70 millivolts. Hypopolarization is the initial graded rise toward threshold and it precedes the spike. Do not confuse it with depolarization. Depolarization is the spike phase itself after threshold, driven by sodium inflow.

The overshoot is the extreme positive part during depolarization. Repolarization follows when potassium leaves the cell. Hyperpolarization follows repolarization because potassium channels close slowly and let out a little too much positive charge. The trace then settles back to rest.

Stronger stimuli do not make larger spikes. Length and amplitude stay the same. Stronger stimuli raise the frequency of spikes. A strong sustained input gives a rapid train of same-size spikes. A weak input gives occasional spikes or none.

The five steps of an action potential, from rest near minus 70 millivolts through threshold, sodium-driven depolarization, potassium-driven repolarization and hyperpolarization, back to rest.
The spike in five steps, with voltages and ions.

Why the signal only moves forward

After each spike the membrane needs a short recovery time. During the absolute refractory period no new spike can start. It overlaps depolarization and about two thirds of repolarization. During the relative refractory period a spike is possible but only with a stronger than normal stimulus. It overlaps the last third of repolarization.

This recovery explains direction. The patch just behind the moving spike is refractory and cannot fire again yet. The only patch ready to fire sits ahead. The signal thus moves forward from the cell body through the axon to the target. It never moves backward under normal conditions.

It also explains why the signal does not weaken. Each ready patch makes a new spike at full size. Propagation is not a passive spread that fades. It is active regeneration at every step.

Myelin and speed

Speed depends on axon diameter and on myelin. Thicker axons conduct faster. Myelinated axons conduct faster than unmyelinated ones of the same width.

Myelin is a fatty cover that insulates much of the axon. It is broken at regular bare gaps. Those gaps are the Nodes of Ranvier. In saltatory conduction only the nodes depolarize in turn. The spike appears to jump from node to node. Fewer patches need to fire, so the signal travels much faster and uses less ion pumping afterward.

In unmyelinated fibers every patch of membrane must depolarize in turn. That makes conduction slow. Myelin thus trades insulation for speed, which matters for fast reactions and for coordinated timing across brain areas. To see how the autonomic branches use these spikes in the body, read how the autonomic branches use these spikes.

What happens at the end

The spike ends at the terminal button. Depolarization there opens calcium channels. Calcium enters the terminal and changes proteins in the presynaptic membrane. Vesicles release neurotransmitter into the synaptic cleft.

The cleft is a narrow gap of about 20 to 40 nanometers between the presynaptic membrane and the target membrane. The transmitter crosses it and binds to receptors on the target side. Those receptors control ligand-gated ion channels. Depending on the transmitter and receptor, ions flow in or out and the target is excited or inhibited.

Central synapses sit between two neurons. Peripheral synapses sit between a neuron and a muscle fiber, gland or peripheral target. In each case the logic is the same. The electrical spike becomes a chemical release, then becomes an electrical change again in the target.

Three mix-ups to avoid

Students lose marks on the same three points. Each has a simple fix.

Graded change against spike.
Graded changeAction potential
Size varies with stimulus strength, fades with distanceSize fixed for the neuron, rebuilt without weakening
No threshold, sums toward thresholdThreshold at about minus 55 to minus 50 millivolts
Can go up or down, stays localAll-or-none, travels forward along the axon

Threshold is not rest. Rest is the stable holding voltage near minus 70 millivolts. Threshold is the trigger level at about minus 55 to minus 50 millivolts. Learn both numbers with their signs. A question that asks for resting value wants minus 70. A question that asks when the spike starts wants the threshold range.

Size is not strength. A larger stimulus does not make a larger spike. It makes more spikes per second. If a question asks how intensity is coded, answer frequency, not amplitude.

How to remember it

Learn the seven labels as one ordered chain. Rest, threshold, depolarization, peak, repolarization, hyperpolarization, refractory period. Then add myelin and Nodes of Ranvier as the speed pair, and calcium and synaptic cleft as the ending pair. That gives eleven terms that cover the core questions on this topic.

Psychology World keeps 23,944 terms in a curated dictionary on iPhone and iPad. Save the eleven terms into one named list, for example signaling basics. Drill that list with Flashcard for recognition, Question for four-option choice when the list holds at least four words, and Typing for recall. Search inside definitions and study progress are Pro features that help you find a term fast and track repeats. The word of the day brings one term each day at a time you choose, and it stays off until you turn it on.

For a method for keeping terms like threshold and myelin, see our guide on how to memorise psychology terms. Keep sessions short and test yourself on the list.

Frequently asked questions

What is an action potential in simple words

It is a short electrical spike that a neuron sends down its axon when its voltage reaches threshold. It has a fixed size, it regenerates without fading, and it ends by releasing a chemical message into the synapse.

What are the phases of an action potential in order

Rest near minus 70 millivolts, depolarization as sodium enters, a brief positive peak, repolarization as potassium leaves, hyperpolarization below rest, then return to rest. Threshold at about minus 55 to minus 50 millivolts starts the sequence.

What is threshold potential in psychology

It is the membrane voltage that triggers a full spike, about minus 55 to minus 50 millivolts. Below it nothing fires. At and above it a full-size spike always fires, and stronger inputs raise spike frequency rather than spike size.

Why does myelin speed up the action potential

Myelin insulates most of the axon so only the Nodes of Ranvier need to fire in turn. The spike jumps from node to node instead of rebuilding at every patch, which raises speed and lowers the pumping work afterward.

Sources

  1. 1.Queensland Brain Institute. Action potentials and synapses.
  2. 2.Eric H. Chudler. Neuroscience for Kids: Lights, Camera, Action Potential.
  3. 3.Jana Vaskovic (2023). Action potential.

Look the terms up yourself

18,000+ psychology and psychotherapy terms in English and German, on iPhone, iPad, Mac and Apple Vision.

See how Psychology World works
All posts